£74.40 inc VAT
Qty

Liquid Crystal Display

Two 5 Volt USB outputs

Lighting control function, fully programmable

Three stage battery charging (bulk, absorption, float), fully programmable

Load output with low voltage and manual disconnect (programmable)

Protected against reverse polarity connection of the solar panels and/or battery.

Battery type: Lead-ACID and LiFePO4 (with internal BMS)

Protected against over current & short circuit

The BlueSolar PWM Charge Controller series uses Pulse Width Modulation (PWM) charge voltage control combined with a multistage charge control algorithm. This charge controller is for 48v set ups.

• Three stage battery charging [bulk - absorption - float]
• Battery type: Lead-ACID and LiFePO4 (with internal BMS)
• Protected against over current.
• Protected against short circuit.
• Protected against reverse polarity connection of the solar panels and/or battery.
• Low voltage load disconnect.
• Temperature protection

Liquid crystal display
For status monitoring and set-up

Load output
Over-discharge of the battery can be prevented by connecting all loads to the load output. The load output will disconnect the load when the battery has been discharged to a pre-set voltage. Some loads (especially inverters) can best be connected directly to the battery, and the inverter remote control connected to the load output. A special interface cable may be needed, please see the manual. The connect and disconnect voltages are adjustable.

Day/night timing of the load output
This option allows for a pre-set ON-time after dusk.

Programmable battery charge algorithm
Preprogrammed algorithms for AGM, GEL, Flooded or LiFePO4 batteries (with internal BMS only)

Two 5 Volt USB outputs
Maximum current (both outputs combined): 2A